NOTES : 
CUSTOMER CALLED TO PLACE SERVICE CALL.  BURNER 2 ILLEAGAL FLAME SENSE AS WELL AS THE ACTUATOR IS GIVING 
CHUTES DID NOT OPEN ERROR.

UPON VERIFICATION THE FLAME SENSOR ON BURNER 2 DID NOT GIVE PROPER CONTINUITY AND MAY LEAK THE SIGNAL 
VOLTAGE THROUGH THE CERAMIC ISOLATOR GIVING THE ILLEAGAL FLAME SENSE.  REPLACED FLAME SENSOR AND ISSUE 
SEEMS TO HAVE BEEN RESOLVED DURING THE DURATION ON SITE WITH NO FURTHER ERRORS.  IT IS NOTED THOUGH THAT IN 
ORDER TO HAVE AN ILLEAGAL FLAME SENSE THE SENSOR NEEDS TO BE SHORTED TO THE BURNER GROUND WHICH WAS NOT 
THE CASE, IT IS POSSIBLE THAT THE PROBLEM MAY REOCCUR AND THE SOLUTION WILL BE TO REPLACE THE SERIES 2000 
BOARD ON BURNER 2

AS FOR THE ACTUATOR, AFTER OBSERVING 4-5 DUMPS IT SEEMS TO FUNCTION AS INTENDED.  NOT A SINGLE FAULT WAS 
PRODUCED WHILE ON SITE, IT IS POSSIBLE THAT THE ERROR MAY HAVE BEEN ARTIFICALLY CREATED BY ANOTHER CONDITION 
WHILE THE SYSTEM WAS DUMPING (ILLEAGAL FLAME SENSE, GRAIN TEMPERATURE HI LIMIT).  CUSTOMER WILL OBSERVE AND 
IF ANY OTHER ISSUES OCCUR REGARDING THE ACTUATOR WE MAY HAVE TO REPLACE THE LIMIT SWITCH THAT GIVES THE 
OPEN/CLOSE CONTACT

PIECES : 
THH-4182

VEHICULES : 
QUITTER 23H15